On Mon, 13 Jul 2020 at 15:19, Cédric Le Goater <c...@kaod.org> wrote: > On 7/10/20 1:33 PM, Peter Maydell wrote: > > Andrew, Cedric: do you have the datasheet for this device? Do you > > know if we should also be flagging the error back to the > > guest somehow? > > zero is the only invalid size of a transmit buffer and the specs does > not have any special information on which bit to raise in that case.
I found a datasheet which might or might not be the equivalent bit of hardware -- does your datasheet have a note on the TXBUF_SIZE field of a tx descriptor that says "When the size is 0, the descriptor would be discarded" ? (Though I found another random doc that just says it's illegal...) > I think FTGMAC100_INT_NO_NPTXBUF (transmit buffer unavailable) is our > best option and we should add an extra 'len == 0' test in front of > the dma_memory_read() call to raise it. A zero length is not considered > bogus by dma_memory_read() it seems. My best guess at "what the hardware does" here would be: * TXBUF_SIZE in a tx descriptor can be anything: the h/w would happily allow you to assemble a tx packet with a whole series of 1-byte sized buffers, each with its own tx descriptor * zero-byte tx descriptors might just be marked "done" and skipped over since they have no actual data * any checking on max/min lengths would be done only on the accumulated total-packet length (we do this this way already for the frame-too-big check) * I suspect "transmit buffer unavailable" means "the ethernet controller needs more data but the next tx descriptor is still marked as owned by the guest" -- this is certainly what we currently do with it, and that doesn't seem like the best thing to signal for the "tx packet too small" case. It's possible that the hardware simply sends out a runt packet of some form if the software tells it to do that. My vote would be for handling it with XPKT_LOST, the same way we do for over-large frames. This probably is not what the hardware does but at least it's a coherent thing that the guest might be expecting to have happen for a tx attempt and it matches the fact that we really are not going to put it on the 'wire'. Side note: I suspect that any failures from dma_memory_read() and dma_memory_write() should be reported as AHB_ERR (currently we have a mix of ignoring them or using NO_NPTXBUF). (It would in theory be possible to test some of these edge cases on real hardware, but that kind of bare-metal test case is usually a pain to put together and way overkill for this situation, so I don't think we should bother.) > Is address zero considered bogus ? > If not, we need to check that also. Writes to address 0 are fine, it is not a special physical address. thanks -- PMM
