Hi Anita -
I've just tried your project on my win8 pc with QGIS 2.3 32 bit and
compared it with my QGIS 2.0 set-up on the same pc:
Start-up times for the "annecy" project (QGIS already started with an
empty project):
* QGIS 2.0: 6.7 sec. every time.
* QGIS 2.3: 1. time 6.9 sec.; 2. time: 7.5 sec.; 3. time: 8.4 sec.
.... 7. time: 11.9 sec. I've loaded an empty project between each
iteration.
It takes between 0.6 - 0.9 sec. longer for each reload of the project.
If I restart QGIS and load the "annecy" project the load time falls to
6.9 sec. again.
The QGIS Code revision number is ca6d4d9.
Regards
Bo Victor Thomsen
Aestas-GIS
Denmark
Den 03-06-2014 14:21, Anita Graser skrev:
Hi Giovanni,
On Tue, Jun 3, 2014 at 12:57 PM, Giovanni Manghi
<[email protected]> wrote:
On Mon, Jun 2, 2014 at 6:38 AM, Anita Graser <[email protected]> wrote:
Hi Giovanni.
I just counted until the map was done rendering: 3 versus approx 21 seconds.
What I see is the following:
on Linux (physical machine) your project opens really fast (~3
seconds) on qgis master
on Windows (virtual machine) the project opens in 7/8 seconds, on both
2.2 and master (there is may be a little difference between the two,
but not as big as your are seeing).
Thanks for your feedback. I'll check a second windows machine, maybe I
just screwed up something on the Win8 machine to cause these huge
differences.
Maybe you could send me a screenshot of the rendering options you are using?
Best wishes,
Anita
_______________________________________________
Qgis-developer mailing list
[email protected]
http://lists.osgeo.org/mailman/listinfo/qgis-developer
_______________________________________________
Qgis-developer mailing list
[email protected]
http://lists.osgeo.org/mailman/listinfo/qgis-developer
