it's possible you prj file isn't getting read properly? what software did you use to create the prj file? you can check the properties of the layer to see if your prj info is correctly specified, and if not, change it manually there... you could also then use the define projection tool from the vector tools to properly specify your prj...
Carson On Tue, Apr 13, 2010 at 3:42 PM, Yves Jacolin <[email protected]> wrote: > Le mardi 13 avril 2010 16:38:39, Micha Silver a écrit : >> I'm not sure I understand. What did you expect to happen? >> With OTF enabled, when you open a vector which is projected in some >> different CRS, the it should appear reprojected into the project CRS. > Hi Micha, > > When I open a file in projection XXX in a QGIS project with a projection YY + > OTF enabled I would like that QGIS read the prj file of my shapefile and > reprojected it correctly. > > My tests showed that the prj file is not read/used by QGIS. > > Am I wrong ? Is it a known limitation depending the prj file? > > Regards, > > Y. > -- > Yves Jacolin > > http://yjacolin.gloobe.org > _______________________________________________ > Qgis-user mailing list > [email protected] > http://lists.osgeo.org/mailman/listinfo/qgis-user > -- Carson J. Q. Farmer ISSP Doctoral Fellow National Centre for Geocomputation National University of Ireland, Maynooth, http://www.carsonfarmer.com/ _______________________________________________ Qgis-user mailing list [email protected] http://lists.osgeo.org/mailman/listinfo/qgis-user
