Finbar,
Crosses should do what you want, if the end point is within the polygon,
then the line must cross the Boundary, I have no tied it myself.
Regards,
Richard
On 09/01/2018 12:31, Finbar Gillen wrote:
Hi all,
I am doing a bit of analysis where I want to select all linestrings
where their end point falls within a polygon feature. Below are the
settings I have used in ‘Select by Location’ Plugin.
Any linestring that falls outside will not be selected, which you
would expect. I don’t want to use ‘intersects’ as an option in the
plugin as it will create an over selection for what I want to do.
Isthere a way where you can specify the linestring end point has to be
within a polygon rather than the whole line? I have the x y coordinate
for the end point within the attribute table.
Regards
Finbar
Finbar Gillen | Data Analyst
Vhi Healthcare| 2 Custom House Plaza, IFSC, Dublin 1
E : [email protected] <mailto:[email protected]>
_______________________________________________
Qgis-user mailing list
[email protected]
List info: https://lists.osgeo.org/mailman/listinfo/qgis-user
Unsubscribe: https://lists.osgeo.org/mailman/listinfo/qgis-user
--
*_Richard McDonnell_*
*GIS Specialist PgD GIS AssocSCSI*
*OPW FRM Data Management*
*52 Stephens Green, Dublin 2.*
TEL: 01 6476543
OPW - Ag féachaint don am atá le teacht - Ag caomhnú ón am atá thart
OPW - Looking to the future - Caring for the past
***********************************************************
Email Disclaimer: http://www.opw.ie/en/disclaimer/
_______________________________________________
Qgis-user mailing list
[email protected]
List info: https://lists.osgeo.org/mailman/listinfo/qgis-user
Unsubscribe: https://lists.osgeo.org/mailman/listinfo/qgis-user
