Op Tue, 19 Apr 2016 17:38:47 +0200 schreef John Gilpin
<[email protected]>:
Hi everyone,
Some time ago, I developed an EASY POINTER routine for an exercise that
my QUANTA Sub-Group were doing and, as part of that exercise, I
developed a menu which proved to be very successful. However, in order
to carry out some fine tuning to this menu, I attempted to load it back
into the Menu routine of EP but got an error message "Menu does not fit
in workspace - Please press any key". Since I only have one version of
EP (EP4) and my menu was developed in this version, I am confused as to
why it will not fit back into the workspace available.
Is there a way that I can overcome this problem? I have thought about
scaling it in some way to make it smaller, but cannot work out how!
Since the only alternative is to redesign the menu from scratch, any
advice to avoid this would be gratefully received.
If you try to open it on the same hardware as it was developed, this is a
strange error.
But I suspect the window size for EasyMenu is too small.
You can check the size set for EasyMenu by opening it in MenuConfig.
There you can set the a new window size to work in, try full screen.
Then it should fit.
For myself I usually design the menus as small as possible with scaling
set, then I can set the proper size from within the program that's using
it.
Also because you never know how big the monitor is of the user.
Bob
--
The BSJR QL software site at: http://members.upc.nl/b.spelten/ql/
_______________________________________________
QL-Users Mailing List
