Hey Jim, Not that it's inappropriate to this list, but I'd post this question to the chkuser list (http://www.interazioni.it/opensource/chkuser/support/mailing_lists.html). I expect that Tonino (who wrote and maintains chkuser) would be able to easily answer this. Please post back here whatever you find out.
Jim Scott wrote: > No just checked and not configured to allow from the IP I was sending > from. Also just checked from a different external IP at home and same > results. I changed the IP for second line to hide the IP from the list. > so ignore the xxx for the one IP that is added to be able to relay. And > not it is not the IP I am testing from ;-) > > 127.:allow,RELAYCLIENT="" > 216.xxx.xxx.:allow,RELAYCLIENT="" > :allow,BADMIMETYPE="",BADLOADERTYPE="M",CHKUSER_RCPTLIMIT="1500",CHKUSER_WRONGRCPTLIMIT="150",QMAILQUEUE="/var/qmail/bin/simscan" > > > Jim > > > > ----- Original Message ----- From: "Erik Espinoza" > <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Wednesday, October 18, 2006 1:15 AM > Subject: Re: [qmailtoaster] Can I switch something to reject unknown > users at SMTP Connection? > > >> Are you sending it from an IP address that is in >> /etc/tcprules.d/tcp.smtp as allowed? >> >> >> On 10/18/06, Jim Scott <[EMAIL PROTECTED]> wrote: >>> I am using QmailToaster which was installed about 6 months ago and don't >>> think I have changed anything that would affect this. >>> >>> I can telnet to the server and issue a ehlo, mail from and rcpt to >>> and type >>> in an invalid user name and it responds ok, I then enter some data >>> and hit >>> dot and it sends. But I then a few seconds later get a bounce back to >>> the >>> email I used from the rcpt to. >>> >>> I can see in SMTPD that it accepts and SEND rejects. >>> >>> Jim >>> >>> ----- Original Message ----- >>> From: "Erik Espinoza" <[EMAIL PROTECTED]> >>> To: <[email protected]> >>> Sent: Tuesday, October 17, 2006 1:57 PM >>> Subject: Re: [qmailtoaster] Can I switch something to reject unknown >>> users >>> at SMTP Connection? >>> >>> >>> >> Currently I can see that the default install accepts all email >>> sent to >>> >> QMAIL. It then evaluates after accepting if the user exists in the >>> >> system. >>> >> If not generates a bounce message. >>> > >>> > That is true for Qmail. We, the QmailToaster, have the chkuser patch >>> > installed which will reject e-mail that doesn't go to a valid user. >>> > >>> >> Is there something I can change so that these users are rejected >>> at >> SMTP >>> >> time? I don't want the system to even accept the email if the address >>> >> does >>> >> not exist on our system. >>> > >>> > Nothing needs to be changed on our default config. >>> > >>> > If you are using a Qmail install other than ours, you may want to go >>> > to their community or check out our installation. :) >>> > >>> > Thanks, >>> > Erik >>> > -- -Eric 'shubes' --------------------------------------------------------------------- QmailToaster hosted by: VR Hosted <http://www.vr.org> --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
