*** This message was automatically generated by the MailMax Error Responder ***
Sorry, your message from <[EMAIL PROTECTED]> to <[EMAIL PROTECTED]> could not be delivered. The specific error is:
Unable to connect to the destination server.
10 attempts will be made to re-send your e-mail. Each attempt will be 4 hours apart.
At 09:50 PM 1/14/2004, Derek C. wrote:
Please see the reply that was sent to you regarding this last week:
When you say, "Local" I'm assuming your using telent from the same system? Can you telnet across the same local area network? You also should check with your ISP and find out what ports they are blocking. They may just portmap 110 to their particular servers. A good thing to investigate before you pull your hair out.
Pete
At 09:01 AM 1/12/2004, Eric wrote:I installed qpopper and tested from local machine and telnet xxx pop3 works fine. However If I telnet from the internet I get nothing , can't connect. thus when I setup outlook I get an error about no port. what am I missing? I've gone through GUIDE.pdf , and looked on the net but to no avail. hmm
Eric
