Hello, Today i've had an issue with the switch header/source feature. I have a project with 3 files: toto.h, toto_p.h and toto.cpp (typical Qt code :-) - First, looking at toto.h, select 'switch header/source', which opens toto.cpp: so far, so good. 'switch header/source' again brings toto.cpp, nice. - Next, looking at toto_p.h, select 'switch header/source', which opens toto.cpp: so far, so good. - Now if i select again 'switch header/source', i go back to toto_p.h... which is consistent with the last switch, but i have no 'simple' way to get back to toto.h. So from this point, the switch header/source always bings: from toto.h or toto_p.h to toto.cpp [OK], and from toto.cpp to toto_p.h...
Looking at the code, i see where this comes from: we correctly look for matching header/source, but only if we have not stored the match yet. After a successful lookup, we store the result (both directions) in a map, to allow recalling it quickly. This is not very usable, but i don't know how we could fix it. One idea could be the switch header/source would iterate over the three files, so that it goes toto.cpp -> toto_p.h -> toto.h -> toot.cpp...? Or maybe it switch to the 'last' used alternative, and cycle other alternatives only if i call the switch header/source again immediately (with no other action/key press in between): toto.cpp -> toto.h (starts with last used alternative) -> toto_p.h -> toto.h ..., while switching from header to source is unaffected. What do you think? Do you see another way out (except using the locator :-) ) Best regards, -- Francois
_______________________________________________ Qt-creator mailing list [email protected] http://lists.qt-project.org/mailman/listinfo/qt-creator
