Crash traceback that I saw:

Backtrace for 11 stack frames:
/usr/lib/libzebra.so.0(zlog_backtrace_sigsafe+0x2c)[0x7fa781d97bf8]
/usr/lib/libzebra.so.0(zlog_signal+0x2ba)[0x7fa781d9750a]
/usr/lib/libzebra.so.0(+0x3a3c6)[0x7fa781da13c6]
/lib/x86_64-linux-gnu/libc.so.6(+0x354a0)[0x7fa78138d4a0]
/usr/lib/quagga/ospf6d(ospf6_clean+0x10)[0x42b66a]
/usr/lib/quagga/ospf6d[0x40a064]
/usr/lib/libzebra.so.0(quagga_sigevent_process+0x45)[0x7fa781da11b1]
/usr/lib/libzebra.so.0(thread_fetch+0x27e)[0x7fa781d8c0fa]
/usr/lib/quagga/ospf6d(main+0x357)[0x40a3da]
/lib/x86_64-linux-gnu/libc.so.6(__libc_start_main+0xf0)[0x7fa781378830]
/usr/lib/quagga/ospf6d(_start+0x29)[0x409f59]
no thread information available


Useless I know.  I can't make it happen again and I'm not sure what I did
to make it happen.  I wasn't even using osp6d, it just happened to be
running.  So I wasn't paying a whole lot of attention to it.  None of the
patches that just got merged down into master should affect this either, so
it's probably a standing problem.  This has my vote for not holding
anything up.

donald




On Fri, Jun 10, 2016 at 2:30 PM, Paul Jakma <p...@jakma.org> wrote:

> On Thu, 9 Jun 2016, Martin Winter wrote:
>
> Round-7 is fine on my compliance tests. Only change are a few ISIS tests
>> which are now passing,
>> no new failures visible.
>>
>> All good from my side to merge this into Master.
>>
>
> Done. Some grumblings on IRC from Donald about seeing some ospf6d crashes.
>
> regards,
> --
> Paul Jakma | p...@jakma.org | @pjakma | Key ID: 0xD86BF79464A2FF6A
> Fortune:
> I must have a prodigious quantity of mind; it takes me as much as a
> week sometimes to make it up.
>                 -- Mark Twain, "The Innocents Abroad"
>
>
> _______________________________________________
> Quagga-dev mailing list
> Quagga-dev@lists.quagga.net
> https://lists.quagga.net/mailman/listinfo/quagga-dev
>
_______________________________________________
Quagga-dev mailing list
Quagga-dev@lists.quagga.net
https://lists.quagga.net/mailman/listinfo/quagga-dev

Reply via email to