Steve, The only plastic bit i can think of on the hand brake cable is the adjuster. It is mounted above the diff and fits in to a hole on the chassis below the tank. You can see/feel it with the rear wheels off. As craig says the cable is a shortened Sierra one. Only the cable is shortened. You then have to make off a new end to fitt in the rear shoe. If the adjuster has gone should not be to bad to get the old one off that will give you an idea about fitting the new one. Adjusting a new one will be fiddly as the adjuster is close to the fuel tank.
Hope this helps Paul Fennings On 9 Nov, 19:52, Steve Kodz <[EMAIL PROTECTED]> wrote: > So something has gone ping and now the handbrake isn't working. I've taken > a brief look underneath and there's a piece of plastic that looks like it > should be attached to something, so I will probably need to replace it. > > Firstly is it possible to do this without removing the diff? > > What cable is used - looking at the distances it's not a Sierra one. > > Regards, > Steve > --www.h4-turbo.co.uk --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [EMAIL PROTECTED] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). -~----------~----~----~----~------~----~------~--~---
