Same here, I had the hose come off the matrix in the engine bay and spray
water through the hole into the cabin and all over the ECU (Which sits
below the heater in mine)

On Thu, 24 Sep 2009 08:52:00 +0100, Jim Hearne <[email protected]> wrote:
> I think you were unlucky with yours as the Ford ecu's are fairly well 
> sealed and the pcb is conformally coated so steam shouldn't really have 
> hurt it.
> I've had 3 or 4 heater matrix's go on various cars and not had any 
> problems other than a wet carpet.
> 
> Jim
> 
> 
> [email protected] wrote:
>> If this is on a car with electronic fuel injection it would be wise to 
>> check any components that may have been affected by steam from the 
>> matrix - as I found out from bitter and expensive experience.
>>  
>> Michael
>>
>> >
> 
> 
> 

--~--~---------~--~----~------------~-------~--~----~
  You received this message because you are subscribed to the Google Groups 
"Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/quantumowners?hl=en

IMPORTANT NOTE: All information presented herewith is provided on an "As Is" 
basis, without warranty or the implication thereof. Neither the Quantum Owners 
Club nor the individuals associated with the Quantum Owners Club or in the 
preparation of the above information shall have any liability to any person or 
entity with respect to liability, loss, or damage caused or alleged to be 
caused directly or indirectly by the instructions contained within this or 
related message(s).
-~----------~----~----~----~------~----~------~--~---

Reply via email to