Jim and Steve,

Thank you both very much for your help on Saturday, the 2+2 already runs a
little better after the alterations to the crankcase breather system. Tick
over is now down to around 1400rpm, so better than was, I hope to replace
the brake servo tomorrow and with luck it will bring the revs down to an
acceptable level at idle, I will post tomorrow evening with the results
providing I can obtain a new servo.

Geoff.

On 11 June 2010 17:02, Jim Hearne <[email protected]> wrote:

> Not disconnect it, leave it connected but unbolted from the throttle body
> so it's always at it's lowest setting.
>
> Jim
>
>
>
> On 11/06/2010 17:01, geoff ward wrote:
>
> Ahh yes, that the thing I just tried disconnecting while ti was running and
> it made no difference. See previous post (they all seem to be getting a bit
> out of order!).
>
> Geoff.
>
> On 11 June 2010 16:50, Jim Hearne <[email protected]> wrote:
>
>> The black module bolted on to the other end of throttle spindle to the
>> linkage.
>> Has a 3 pin connector on it.
>> Otherwise known as the throttle position sensor.
>>
>> Jim
>>
>>
>>
>> On 11/06/2010 16:46, geoff ward wrote:
>>
>> Sorry Jim, I am not sure what the "throttle pot" is! what does it look
>> like and where Will find it?
>>
>> Geoff.
>>
>> On 11 June 2010 16:26, Jim Hearne <[email protected]> wrote:
>>
>>> No, just the throttle pot.
>>>
>>> Jim
>>>
>>>
>>>
>>> On 11/06/2010 16:07, geoff ward wrote:
>>>
>>> Do you mean remove the throttle body from the manifold?
>>>
>>> Geoff.
>>>
>>> On 11 June 2010 15:55, Jim Hearne <[email protected]> wrote:
>>>
>>>> It's possible, remove it and see if it then hits the stop, also try
>>>> running the engine with the throttle pot removed from the body but still
>>>> plugged in.
>>>>
>>>> Jim
>>>>
>>>>
>>>>
>>>> On 11/06/2010 15:54, geoff ward wrote:
>>>>
>>>>  Could the sensor its self be stopping the butterfly from returning to
>>>> closed, once the engine has done anything more than tick over?
>>>>
>>>> Geoff.
>>>>
>>>>  On 11 June 2010 15:49, geoff ward <[email protected]> wrote:
>>>>
>>>>>  Yes it is sealed, I would have attempted to adjust the angle of the
>>>>> metal lever that the grub screw comes into contact with, naughty I know!
>>>>>
>>>>> Geoff.or related message(s).
>>>>>
>>>>  --
>>>> You received this message because you are subscribed to the Google
>>>> Groups "Quantum Owners Group" group.
>>>> To post to this group, send email to [email protected]
>>>> To unsubscribe from this group, send email to
>>>> [email protected]
>>>> For more options, visit this group at
>>>> http://groups.google.com/group/quantumowners?hl=en
>>>>
>>>> IMPORTANT NOTE: All information presented herewith is provided on an "As
>>>> Is" basis, without warranty or the implication thereof. Neither the Quantum
>>>> Owners Club nor the individuals associated with the Quantum Owners Club or
>>>> in the preparation of the above information shall have any liability to any
>>>> person or entity with respect to liability, loss, or damage caused or
>>>> alleged to be caused directly or indirectly by the instructions contained
>>>> within this or related message(s).
>>>>
>>>
>>> --
>>> You received this message because you are subscribed to the Google Groups
>>> "Quantum Owners Group" group.
>>> To post to this group, send email to [email protected]
>>> To unsubscribe from this group, send email to
>>> [email protected]
>>> For more options, visit this group at
>>> http://groups.google.com/group/quantumowners?hl=en
>>>
>>> IMPORTANT NOTE: All information presented herewith is provided on an "As
>>> Is" basis, without warranty or the implication thereof. Neither the Quantum
>>> Owners Club nor the individuals associated with the Quantum Owners Club or
>>> in the preparation of the above information shall have any liability to any
>>> person or entity with respect to liability, loss, or damage caused or
>>> alleged to be caused directly or indirectly by the instructions contained
>>> within this or related message(s).
>>>
>>>  --
>>> You received this message because you are subscribed to the Google Groups
>>> "Quantum Owners Group" group.
>>> To post to this group, send email to [email protected]
>>> To unsubscribe from this group, send email to
>>> [email protected]
>>> For more options, visit this group at
>>> http://groups.google.com/group/quantumowners?hl=en
>>>
>>> IMPORTANT NOTE: All information presented herewith is provided on an "As
>>> Is" basis, without warranty or the implication thereof. Neither the Quantum
>>> Owners Club nor the individuals associated with the Quantum Owners Club or
>>> in the preparation of the above information shall have any liability to any
>>> person or entity with respect to liability, loss, or damage caused or
>>> alleged to be caused directly or indirectly by the instructions contained
>>> within this or related message(s).
>>>
>>
>> --
>> You received this message because you are subscribed to the Google Groups
>> "Quantum Owners Group" group.
>> To post to this group, send email to [email protected]
>> To unsubscribe from this group, send email to
>> [email protected]
>> For more options, visit this group at
>> http://groups.google.com/group/quantumowners?hl=en
>>
>> IMPORTANT NOTE: All information presented herewith is provided on an "As
>> Is" basis, without warranty or the implication thereof. Neither the Quantum
>> Owners Club nor the individuals associated with the Quantum Owners Club or
>> in the preparation of the above information shall have any liability to any
>> person or entity with respect to liability, loss, or damage caused or
>> alleged to be caused directly or indirectly by the instructions contained
>> within this or related message(s).
>>
>>  --
>> You received this message because you are subscribed to the Google Groups
>> "Quantum Owners Group" group.
>> To post to this group, send email to [email protected]
>> To unsubscribe from this group, send email to
>> [email protected]
>> For more options, visit this group at
>> http://groups.google.com/group/quantumowners?hl=en
>>
>> IMPORTANT NOTE: All information presented herewith is provided on an "As
>> Is" basis, without warranty or the implication thereof. Neither the Quantum
>> Owners Club nor the individuals associated with the Quantum Owners Club or
>> in the preparation of the above information shall have any liability to any
>> person or entity with respect to liability, loss, or damage caused or
>> alleged to be caused directly or indirectly by the instructions contained
>> within this or related message(s).
>>
>
> --
> You received this message because you are subscribed to the Google Groups
> "Quantum Owners Group" group.
> To post to this group, send email to [email protected]
> To unsubscribe from this group, send email to
> [email protected]
> For more options, visit this group at
> http://groups.google.com/group/quantumowners?hl=en
>
> IMPORTANT NOTE: All information presented herewith is provided on an "As
> Is" basis, without warranty or the implication thereof. Neither the Quantum
> Owners Club nor the individuals associated with the Quantum Owners Club or
> in the preparation of the above information shall have any liability to any
> person or entity with respect to liability, loss, or damage caused or
> alleged to be caused directly or indirectly by the instructions contained
> within this or related message(s).
>
>   --
> You received this message because you are subscribed to the Google Groups
> "Quantum Owners Group" group.
> To post to this group, send email to [email protected]
> To unsubscribe from this group, send email to
> [email protected]
> For more options, visit this group at
> http://groups.google.com/group/quantumowners?hl=en
>
> IMPORTANT NOTE: All information presented herewith is provided on an "As
> Is" basis, without warranty or the implication thereof. Neither the Quantum
> Owners Club nor the individuals associated with the Quantum Owners Club or
> in the preparation of the above information shall have any liability to any
> person or entity with respect to liability, loss, or damage caused or
> alleged to be caused directly or indirectly by the instructions contained
> within this or related message(s).
>

-- 
You received this message because you are subscribed to the Google Groups 
"Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/quantumowners?hl=en

IMPORTANT NOTE: All information presented herewith is provided on an "As Is" 
basis, without warranty or the implication thereof. Neither the Quantum Owners 
Club nor the individuals associated with the Quantum Owners Club or in the 
preparation of the above information shall have any liability to any person or 
entity with respect to liability, loss, or damage caused or alleged to be 
caused directly or indirectly by the instructions contained within this or 
related message(s).

Reply via email to