The rear bumper is bolted across the narrow inside rear panel just behind
where the boot lid closes and it is also screwed either side to the wings.
The number of fixings was open to interpretation by the builder,
particularly as the outermost bolts are very awkward to reach and the wing
screws tend to pull out so may well have been replaced by bolts or
reinforcement.
I did something similar in a churchyard whilst looking for the resting place
of certain ancestors. The bumper was easy enough to rebuild but finding a
yellow paint to match the aging and rapidly going transparent yellow gelcoat
has proved to be difficult!
Hamish
Much to my annoyance, 10 days ago I messed up reversing into my own
drive to the detriment of the rear bumper of my H4. I appear to have
pulled one side off (drivers side) and split the moulding slightly in
the centre. My query is...how is the thing held on...and what is it
made of? It looks to me as if it's bolted at both ends and clipped
onto the side panels...and made of fibreglass / grp.
Had I built the car, I would know this stuff...but I didn't and my
build manual isn't too helpful (I'm not even sure that it's complete).
The plan would be to remove, repair and refix, of course...am I likely
to find this straightforward ?
Thanks
--
You received this message because you are subscribed to the Google Groups
"Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum
Owners Club nor the individuals associated with the Quantum Owners Club or
in the preparation of the above information shall have any liability to any
person or entity with respect to liability, loss, or damage caused or
alleged to be caused directly or indirectly by the instructions contained
within this or related message(s).
--
You received this message because you are subscribed to the Google Groups "Quantum
Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor
the individuals associated with the Quantum Owners Club or in the preparation of the
above information shall have any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused directly or indirectly by the
instructions contained within this or related message(s).
