I also agree that the pinto on standard mounts, does fit under the bonnet, just the oil filler needed to be tweaked to fit under, before this it was only just rubbing.
I am lucky enough to have side draught carbs and thus no height issues that side. tiger do more solid smaller rubber blocks for engine mounting that work with a pinto. I have also been advised that this may not be a bad idea as it will also assist in stopping the engine rocking so much and putting stress on the exhaust welds. mine came apart where the pipe is welded onto the flat plate that you bold onto the head. I've not changed them yet so can't comment if it is a good idea or not. chris -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s).
