Mark, I don't have the details (or the car) to hand, but from memory I needed just to drill out the holes by a couple of mm - i.e. spacing and offset was correct - and just trimmed a millimetre or so from the outboard side of the hub to move the calliper frame inwards slightly. There are two sizes of Mk2 Mondeo discs; from memory, these are the smaller (260mm).
Neil On Apr 6, 12:35 pm, Mark Miles <[email protected]> wrote: > With the mondeo discs do you need to make any modifications to the two holes > on the hub assembly that mount the caliper bracket. I bought a set of discs > and twin pot calipers that were apparently suitable for an escort. In order > to fit them I would need to put spacers in to move the caliper outboard by > about 6mm as well as milling the discs down by 2mm (diameter) as they foul > the caliper. It all seems rather a lot of work, especially if the mondeo disc > will be a straight fit. My local breakers has two v6 mondeos with complete > braking systems at the moment. I already have 15" wheels so no problem there. > -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s).
