I've had the engine and gearbox out of my Xtreme to get the bottom end
rebuilt. While the engine was away I cleaned the gearbox, and replaced the
oil seal. With the gearbox bell housing back in place I thought I would
check gear selection before putting it back on the engine and that is where
my worry has started.
I can select all 5 forward gears, but it does not want to go into reverse.
The movement feels fine and I can push the lever down and right, but even
with a good shove it will not go into reverse.
Is there anything that I could have disturbed when removing the bell housing?
Regards,
Steve
--
--
You received this message because you are subscribed to the Google Groups "Quantum
Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor
the individuals associated with the Quantum Owners Club or in the preparation of the
above information shall have any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused directly or indirectly by the
instructions contained within this or related message(s).
---
You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/quantumowners/17a6bead530.2816.a0c0b4d6271d57d23c324d40517c1814%40h4-turbo.co.uk.
