On Saturday, 17 February 2018 15:07:55 UTC, Elias Mårtenson wrote: > On Saturday, 17 February 2018 22:55:20 UTC+8, Marek Marczykowski-Górecki > wrote: > > > That's weird, it should be enabled in sys-net by default. Did you had > > any problems during installation, requiring manual sys-net setup? > > The installation worked fine as far as I can tell. > > The only unusual thing was after initial boot, when it initialises the system > for the first time (the part where you answer which vm's you want created, > etc). After I had done this, you're supposed to click "finish" (or something > to that effect) but I accidentally clicked on the same button again. This > caused the installer to run again. > > I don't think that would cause any issues, but that's the only thing I did > that was out of the ordinary. > > After adding the clocksync service to sys-net, activating it, and rebooting, > the time is now properly synchronised. > > Regards, > Elias
I can confirm that I had the same problem. I did the same mistake during install on one of my systems, not sure it was on the one at fault, but quite probably. Another system I installed later is fine (I probably did not do the install mistake). -- You received this message because you are subscribed to the Google Groups "qubes-devel" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/qubes-devel/839695ae-5e75-4852-ab25-3d78cdcf1407%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
