On 2017-05-09 19:47, cooloutac wrote:
On Tuesday, May 9, 2017 at 10:27:38 AM UTC-4, [email protected] wrote:
Hi there,
I've had to install Qubes without sys-usb because some of the devices
attached to one of the usb buses would not work (touchscreen, memory
socket), even after reassigning the relevant USB bus o dom0 as I used
to
do in Qubes 3.1.
After installing Qubes 3.2 without sys-usb, I created a service vm for
usb devices and on the VM services configuration tab I assigned the
second USB which carries two USB ports to this newly created "custom
sys-usb" VM.
However, when I start this VM and then plug-in my USB stick, the do
not
show anywhere, not even in dom0, as if the second USB bus had
vanished.
What can I do to selectivly assign USB buses to sys-usb and make them
work?
Thanks in advance,
A
https://www.qubes-os.org/doc/usb/ if you already used qubesctl
doublecheck that.<
in 3.2 you can try just adding the
"single usb device". https://www.qubes-os.org/doc/assigning-devices/
_______________________________________________________________________
I did what you suggested but instead of doing it from the command line,
I did it directly from Qubes Manager on the VM Services configuration
tab with the result I described on my first email.
The USB devices are not available on my "custom" sys-usb and neither on
dom0. It looks as if the whole bus had been disabled....
--
You received this message because you are subscribed to the Google Groups
"qubes-users" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To post to this group, send email to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/qubes-users/04666e10bcf76afd07d237eeb878ba0e%40grrlz.net.
For more options, visit https://groups.google.com/d/optout.
