Hi, Here's a HCL for a new laptop. I have it for about 2 weeks, I had to solve a couple minor issues, but in general everything seems to be working.
The install worked on the second attempt. The first attempt seemed to be stuck on a blank console / screen on the restart, but I tried again and this time it finished fine. I suspect I might have been impatient - perhaps if I gave it a bit more time it'd work the first time. Not sure. The suspend/resume seems to work fine. I disabled hyperthreading and added mem_sleep_default=deep to grub, but mostly because that's what was needed on the previous machine. Maybe it'd work without this, not sure. At first I thought it doesn't suspend correctly, because the fans take quite a while (a minute or more) to actually stop. I had to increase the memory limits for sys-net - without it, the wifi stopped working on suspend/resume. There an iwlwifi message about page fault in dmesg, and restarting sys-net fixed it. But after increasing memory from (default) 400MB to 800MB it works fine. The only issue I'm aware of is that if I attach/detach yubikey to the USB-C port on the right side, the machine powers off (just dies after a second or so). It doesn't happen with the USB-C controllers on the left side, and it doesn't happen in Fedora either (which is what the laptop had preinstalled). I believe the laptop has multiple controllers - USB, NHI and Thunderbolt 4, so maybe xen has problem with one of those. I haven't tried if there's a newer kernel (I'm on 6.11.2-1 at the moment). regards -- You received this message because you are subscribed to the Google Groups "qubes-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to qubes-users+unsubscr...@googlegroups.com. To view this discussion visit https://groups.google.com/d/msgid/qubes-users/562a9ea4-5b36-449f-a7c8-647a8758227dn%40googlegroups.com.
Qubes-HCL-LENOVO-21KVS0B300-20241028-192620.yml
Description: application/yaml
