jay wrote:
Help me again!!
1. I did installed NTP on all computers!
2. In ntp.conf file of Computer 1 , I added this lines
server 127.127.1.0
fudge 127.127.1.0 stratum 10
OK
<>
3. In ntp.conf file of Computer 2, I addes this lines
server 192.168.xxx.xxx iburst minpoll 4 maxpoll 7
Is this correct? Should I replace xxx with numbers? How do I know that?
You must replace the xxx.xxx with the proper numerical values. Use the
IP address of Computer 1.
<>I also tried with
server isolated.network.server iburst
However, I'm not sure this works.
I found that the commend 'ntpq -p' shows if ntp works properly but the
window disappear so fast I cannot read anything. :(
Is there any way that I can see(monitor) the performance ? ( I tried
some but it looks its not working...)
Thank you!
_______________________________________________
questions mailing list
[email protected]
https://lists.ntp.isc.org/mailman/listinfo/questions
