>> And here what I get with it: >> >> remote refid st t when poll reach delay offset >> jitter>==============================================================================> >> GPS_NMEA(0) .GPS. 0 l - 64 0 0.000 0.000 >> 0.001 >> > > The 0 under reach says you aren't getting any data from that system. > > > >> nmea: gpsread 72 >> $GPGGA,151022.00,5225.83871,N,01316.84595,E,1,07,0.99,39.8,M,44.9,M,,*60 >> > > That says the unit is working and providing GPGGA info. The 1 after the E > says it thinks the data is valid. (aka it is hearing enough satellites) > > Go back up and look at the config file. The default for the NMEA driver > is to expect GPRMC sentences. So you should either fix your unit to > send them (and not waste time with the GPGGA stuff) or fix your config > file to use the GPGGA sentences. I think that takes a mode subcommand. > > Thx a lot for that hint! Strangely the unit sometimes comes with GPRMC sentenses and sometimes not, so I configured ntpd to use the GPGGA sentenses. Just had to add 'mode 2' to the config line of the gps device.
Best regards, ../nico berndt _______________________________________________ questions mailing list [email protected] https://lists.ntp.org/mailman/listinfo/questions
