You should use "maxpoll n" option. The length of the intervall will be 2^n seconds. Example configuration file should look like this:
server 192.168.0.2 maxpoll 3 2013/5/15 Miguel Gonçalves <[email protected]> > Hi! > > I am trying to figure out why NTP takes so long to react to oscillator > changes... > > When checking ntptime on startup I see that the NTP daemon is using > PLL and starts the adjustment interval at 8 s. It then increases to > 16, 32, 64, 128 and stops at 256. > > I read in the documentation that this limit should be 128 but is now 256. > > --- start from http://www.ntp.org/ntpfaq/NTP-s-config-adv.htm --- > intervals 57 says that there were 57 calibration intervals. When PPS > pulses are arriving, this number should increase. Each frequency > adjustment requires a good calibration interval. The length of the > current calibration interval can be found as interval 128 s (128 > seconds is the default maximum length). Remaining numbers count > abnormal conditions as explained below. > --- end --- > > How can I make it stop earlier? At 64 s for example? > > TIA, > Miguel > _______________________________________________ > questions mailing list > [email protected] > http://lists.ntp.org/listinfo/questions > > _______________________________________________ questions mailing list [email protected] http://lists.ntp.org/listinfo/questions
