Le 6 févr. 2014 à 10:58, [email protected] a écrit : <snipped>
> > Now, when i start the ntp service, i get below output for ntpq -p command: > > > remote refid st t when poll reach delay offset jitter > ============================================================================== > *GPS_NMEA(0) .GPS. 0 l 4 16 377 0.000 4526.86 1269.17 > > Problem: Though i have configured my ntp.conf file for nmea and 1pps both > (using flag1 1), i do not see any entry for PPS in ntpq -p command. > if kernel has registered pps0 as pps source, why there is not PPS entry. I > have connected pps signal of 3.3v level to my dcd pin of ttyO1. You might check that your pps signal is being detected watch -n1 "cat /proc/interrupts" > _______________________________________________ questions mailing list [email protected] http://lists.ntp.org/listinfo/questions
