Thanks Tom
I have this schematic but it does not show S-119 aka the Break-in switch.  

C-2 of TM 11-854 describes the mod but there is no schematic that shows S-119 
in series with K-101's coil.  I'm beginning to think that this modified R-388 
might have been part of the GRC-26/B or C shelters.  The operation of the 
Break-in switch is mentioned in TM 11-5829-202-10 aka TO32R2-2GRC-26-151 on 
page 49.  But all illustrations of the R-388 in the manual show a speaker jack 
instead of the Break-in switch.

Actually, the dreaded previous owner has removed K-101 from this receiver and 
used the terminal strip on the rear apron for another purpose.  When I pull the 
front panel I will check to see if the wires to S-119 are tucked out of site.  
I should be able to replace K-101 from my junk-box so I might be able to return 
this particular R-388 back to almost original configuration.

The rear of this receiver had seen some rough handling.  Some sheet metal 
bending was needed to straighten the rear apron and the fuse holder needed 
replacement along with a new line cord.  I am going through two R-388 found at 
the Orlando Hamfest two years ago.  Both have the Break-in switch.  I have a 
51J-4 that is in need of three ferrite slugs.  The hope was that one of these 
two receivers would be an organ donor but so far it looks like at least one is 
serviceable.
Regards,
Jim
Logic: Method used to arrive at the wrong conclusion, with confidence.  Murphy 

    On Saturday, April 6, 2024 at 01:29:51 PM CDT, Tom Frobase 
<[email protected]> wrote:  
 
 Pretty simple attached from 388 schematic.
On Sat, Apr 6, 2024 at 10:41 AM Jim Whartenby via R-390 <[email protected]> 
wrote:

On the bench is a R-388 with a defective Break-in switch mounted in place of 
the speaker jack on the front panel.  Turns out that the switch was not 
connected to the wiring harness.  A check of the various R-388 manuals on hand 
does not show how this switch was connected.  Change 2 of TM 11-854 mentions 
the Break-in switch but there is no other information.
Does anyone have a link to a schematic that shows this Break-in 
switch?Regards,Jim
Logic: Method used to arrive at the wrong conclusion, with confidence.  Murphy
______________________________________________________________
R-390 mailing list
Home: http://mailman.qth.net/mailman/listinfo/r-390
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
  
______________________________________________________________
R-390 mailing list
Home: http://mailman.qth.net/mailman/listinfo/r-390
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

Reply via email to