I may be faced with desoldering and soldering to one of the U-shaped solder posts that has a phenolic base. I remember having problems with those in my R-390A/URRs where heat and just a little force could all-too-easily break the phenolic support.
Any good hints on doing this without breakage? I think this one may not be too difficult because it appears the component's leads are not that tight on the posts and may slide off the ends of the posts without too much "pull" once the solder melts. I'm contemplating just using quigs but would prefer to make things a bit neater without them if possible. Thanks, Barry - N4BUQ ______________________________________________________________ R-390 mailing list Home: http://mailman.qth.net/mailman/listinfo/r-390 Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
