Robert,
try try().
Andrew.
On Wed, Jul 19, 2006 at 10:27:07AM +0200, Robert Mcfadden wrote:
> Dear All,
>
> I wrote a program and there is a loop. At each iteration I use maximum
> likelihood factor analysis (?factanal). Output of factor analysis I use
> later (in this loop). Unfortunately from time to time I get an error message
> (I paste it below) and everything is stopped. Is it possible to write a
> condition that if error appears in factor analysis (FA), change input data
> for FA and do it again? Example
>
>
>
> for (i in 1:1000){
>
> FA<-factanal(data,factor=3)
>
> If error appears change data to data2 and do factor analysis again
>
> #rest of the program
>
> ............
>
> ............
>
> }
>
>
>
> Best,
>
> Robert
>
>
>
> Error in optim(start, FAfn, FAgr, method = "L-BFGS-B", lower = lower, :
>
> L-BFGS-B needs finite values of 'fn'
>
> In addition: Warning message:
>
> NaNs produced in: log(x)
>
>
>
>
>
>
>
>
>
>
> [[alternative HTML version deleted]]
>
> ______________________________________________
> [email protected] mailing list
> https://stat.ethz.ch/mailman/listinfo/r-help
> PLEASE do read the posting guide http://www.R-project.org/posting-guide.html
> and provide commented, minimal, self-contained, reproducible code.
--
Andrew Robinson
Department of Mathematics and Statistics Tel: +61-3-8344-9763
University of Melbourne, VIC 3010 Australia Fax: +61-3-8344-4599
Email: [EMAIL PROTECTED] http://www.ms.unimelb.edu.au
______________________________________________
[email protected] mailing list
https://stat.ethz.ch/mailman/listinfo/r-help
PLEASE do read the posting guide http://www.R-project.org/posting-guide.html
and provide commented, minimal, self-contained, reproducible code.
