Hello,
We've done some additional programming to radiator (created some objects at
the start of radiator) however we're not yet able to find the location of
the code where the shutdown procedure is handled and which we need to remove
the created objects. The obvious location in the main loop (if ($shutdown),
SIG_TERM etc.) does not work for us, as we run radiator on NT.
Could anyone inform us about the location where NT jumps to with a service
shutdown?
Thanks in advance,
Karel van der Velden
----------------------------------------------------------------------------
---
Karel van der Velden | Telephone : +31 50 5851003
KPN Telecom | Telefax : +31 50 5853454
ICT/BPG P&C 2 | E-mail : [EMAIL PROTECTED]
P.O. Box 188 | DISCLAIMER: This Statement is not an
official
NL-9700 AD Groningen | statement from, nor does it represent an
The Netherlands | official position of, KPN Telecom
----------------------------------------------------------------------------
---
===
Archive at http://www.starport.net/~radiator/
Announcements on [EMAIL PROTECTED]
To unsubscribe, email '[EMAIL PROTECTED]' with
'unsubscribe radiator' in the body of the message.
