Hello, I have a 3Com Super Stack II RAS 1500 server and I am running NT 4.0 SP6 with ActiveState Perl build 517 ver 5.005_03. I have an interesting problem with the NAS-Port in the Accounting information with Radiator 2.16.1 with the latest patches as of June 23. When a session starts, it reports the correct NAS-Port #, and it does so also when that session stops, but if there is another session that starts and then stops between the starting and stopping of the first session, the NAS-Port # for the first session is reported wrong on the STOP packet. In fact, it uses the STOP NAS-port # of the session in between for the STOP NAS-Port # of the first session. For example: s1 Acct-Status-Type = Start s1 NAS-Port = 3 s1 Acct-Status-Type = Stop s1 NAS-Port = 3 That works fine, but here is the problem: s1 Acct-Status-Type = Start s1 NAS-Port = 3 s2 Acct-Status-Type = Start s2 NAS-Port = 5 s2 Acct-Status-Type = Stop s2 NAS-Port = 5 s1 Acct-Status-Type = Stop s1 NAS-Port = 5 *********This should be 3 This could be the device and not Radiator, but I want to check with the list first. I have a syslog running for this too, and it shows the correct interfaces when sessions start and stop. This makes me lean toward Radiator as the problem. Not sure though. Please help.... Thanks, -- Brad -- Bradley Clayton Agriculture Information Systems Engineer Purdue University === Archive at http://www.starport.net/~radiator/ Announcements on [EMAIL PROTECTED] To unsubscribe, email '[EMAIL PROTECTED]' with 'unsubscribe radiator' in the body of the message.
