> -----Original Message-----
> From: 'Dan Melomedman' [mailto:[EMAIL PROTECTED]]
> Sent: Monday, February 03, 2003 2:14 PM
> To: [EMAIL PROTECTED]
> Subject: Re: (RADIATOR) radiator stops ...
>
>
> Matthew Trout wrote:
> > > Of course Easysoft OOB is even better as far as
> > > compatibility/reliability are concerned, albeit at a higher cost.
> >
> > You're kidding, right?
> >
> > In production use, Easysoft is absolutely lovely bar for
> one minor 'feature'
> > (at least in the version I had) - if the NT side of the
> Easysoft bridge hits
> > the full number of permitted threads it then refuses to
> accept any further
> > connections without a stop/start on the service. I got
> bored of trying to
>
> We didn't have problems you had with it. In fact we switched from
> FreeTDS to OOB becasue FreeTDS was too flaky for us.
Hmm ... I guess the answer is YMMV, then.
To anyone looking for solutions like this, I would say that Easysoft were very helpful getting their stuff up and running, and your best bet is probably to try both. It was certainly better than Openlink, and I believe their pricing is more competitive as well.
But I'll stick with FreeTDS myself, thanks.
> ===
> Archive at http://www.open.com.au/archives/radiator/
> Announcements on [EMAIL PROTECTED]
> To unsubscribe, email '[EMAIL PROTECTED]' with
> 'unsubscribe radiator' in the body of the message.
>
