Hello,
I am using Radiator 4.11.
I will show relevant portions of my config and then comment on them (IP
addresses changed and Secret ***'d out to protect the guilty):
----------
BindAddress ipv6:::
AuthPort 1812
AcctPort 1813
# ipv6 client
<Client ipv6:2620:0:e50:100::100>
Secret ***
DupInterval 0
AddToReply Session-Timeout=0,cisco-avpair=shell:roles="network-admin"
</Client>
# ipv4 client
<Client 128.255.90.90>
Secret ***
DupInterval 0
AddToReply Session-Timeout=0,Filter-Id=15
</Client>
# ipv4 subnet
<Client 128.255.100.0/24>
Secret ***
DupInterval 0
AddToReply Session-Timeout=0,Filter-Id=10
</Client>
----------
When I use the "BindAddress ipv6:::" configuration parameter, neither of the
IPv4 client definitions work. Radiator will give the following log message:
Wed Jun 26 16:56:38 2013: NOTICE: Request from unknown client 128.255.90.90:
ignored
In the above configuration, the IPv6 client works just fine.
If I add a "<Client DEFAULT>" clause when I still have the "BindAddress
ipv6:::" parameter configured, the IPv4 clients that I want to match more
specifically will match on the DEFAULT client stanza. I cannot have a DEFAULT
client stanza in my config.
Additionally, if I remove the "BindAddress ipv6:::" parameter from the config
(or comment it out), then the IPv4 clients work as expected.
It appears that when I enable IPv6 like above, that I lose my ability to match
on more specific IPv4 client clauses, and I have to use the DEFAULT client
stanza, which is not an option for me.
Thoughts? Any help is appreciated.
-Jason
_______________________________________________
radiator mailing list
[email protected]
http://www.open.com.au/mailman/listinfo/radiator
