[RBASE-L] - System Crashing when printing reports

[Javier Valencia]

I have run into this problem, when I used an older version (patch) of R:Base to look at a report that was saved under the latest patch. If you have backup, delete the report from the database and reload the report from you backup. There was a thread on the MB a while back that addressed this issue. Good luck…   Javier Valencia, PE President Valencia Technology Group, L.L.C. 14315 S. Twilight Ln., Suite #14 Olathe, KS  66062-4571 (913)829-0888 (913)649-2904 FAX   -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Ben Strickland Sent: Sunday, December 22, 2002 4:54 PM To: RBASE-L Mailing List Subject: [RBASE-L] - System Crashing when printing reports   Thanks Javier,   It appears to be in the report itself.  Do have any suggestions?   Benjamin ----- Original Message ----- From: Javier Valencia To: RBASE-L Mailing List Sent: Sunday, December 22, 2002 5:35 PM Subject: [RBASE-L] - System Crashing when printing reports   Benjamin: Any time R:Base crashes it shows a problem with RBG65.exe (unless the computer freezes). I would carefully follows the code, particularly the lines before the point where your application crashes (use TRACE), looking at the variables and checking whether they have the correct type and /or value; many times variables are redefined and create problems. Most of the time, you will find that there is a problem with your code and or variables, you can also use R:Style to check your code. I recently run into a problem caused by a Blob loaded with the initial application screen that caused the system to crash way down the code. Mike Willochel at RBTI finally figure this out and he  was able to come up with workaround to this particular problem. If after all you efforts you still cannot find the problem, give tech. support a call, I have found then to be very responsive and helpful.   Javier Valencia, PE President Valencia Technology Group, L.L.C. 14315 S. Twilight Ln., Suite #14 Olathe, KS  66062-4571 (913)829-0888 (913)649-2904 FAX   -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Ben Strickland Sent: Sunday, December 22, 2002 1:38 PM To: RBASE-L Mailing List Subject: [RBASE-L] - System Crashing when printing reports   Has anyone had the problem printing reports and what is happening is when I change to another [where] condition or change reports in my code, the program crashes showing problems with the RB65.exe file?  What could be possibly wrong with the system or code?  I am using the latest version of Rbase, 6.5++ including the latest patch.   Benjamin Strickland