In my case, I use transaction data to print a receipt for the patient on a blank sheet, but use the exact same data to print to a preprinted HCFA form. It does require a bit of experimentation to locate each field, but once you have it, you have it for good (until the next time they change your form style).
bill
Jim Van Dillen wrote:
I have an application which produces court memorandums (reports) from column values taken from a table and data which is input from the keyboard to populate variables which are then used in the report.
On any particular case sometimes two memos are required, one we produce in whole on a tractor-feed dot-matrix printer and a second which is a court-supplied form which we fill in. The idea is to produce a run of court memos for all the cases on a docket on the tractor feed printer and then switch to sheet feed on the dot-matrix printer to produce the memos on the cases which require the second memo on the court-supplied form. At present we are entering data and extracting column values to produce the tractor-feed memos and then having to go back at the end to type in the info on the court form. This particular court will not accept our similar appearing forms, only their own forms, filled-in.
My idea is to somehow save both the inputed data and the extracted table data for each file while or after producing the tractor feed memo, possibly to a temporary table and then, after inputing for all the files on a docket and producing the tractor feed form memo, have a procedure, possibly with a WHILE loop, to go through the temporary table to print each court form memo in each case where it is appropriate, selecting records based on a condition (e.g. - where a summons is requested - the court memo form) to be printed out on the dot matrix printer after it has been switched over to single sheet feed for the court form.
This would save an enormous amount of time since the info would have to be inputed and/or extracted only once for each record but still produce a report on two different passes through the printer, one tractor feed and one single sheet feed. I assume I can use a PROJECT to get the column values into the temporary table for each record but how would I get the inputed data which is in variables into the temporary table? Would I set up columns in the Temporary table somehow to hold the variable data inputed for each record and how to get the data into the Temporary table?
Any help or guidance would be greatly appreciated.
VAN DILLEN and FLOOD, P.C. JIM VAN DILLEN #4599 ARN #22232 MBE Attorney at Law 1505 S. Big Bend Blvd. St. Louis, MO. 63117 (314) 645-8008; Fax (314) 645-8016 [EMAIL PROTECTED]
.
