Thanks for the tips Razzak. I have narrowed it down to a report that I modified. It works fine on my development system but gets the stream read error at all of my remote accounts. I restored the backup report and it works fine at the remotes that I have tested so far. Some of my accounts are a rev behind (V8 compiled). I will bring the lagers up to 31212 next week. Although, the error occurs on the build 31212 at the remote sites that are running that build. I thought that the report may have gotten corrupted when I unloaded it but I have unloaded it several times and it still fails at the remotes. I also installed it on three of my test databases (on my development PC) and it works fine there. Thanks again John
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of A. Razzak Memon Sent: Saturday, December 20, 2008 12:17 AM To: RBASE-L Mailing List Subject: [RBASE-L] - Re: Stream Read Error At 11:55 PM 12/19/2008, John Engwer wrote: >Does any know what causes "Stream read errors" (no error number). I just >started getting the errors a week or so ago. It seems to happen after a >form closes. John, That is the result of reading a bad BLOB data! A few suggestions: 01. Revisit any custom EEP defined as "On Form Close". 02. Open every single form in question in a form designer and review everything accordingly. If you haven't made any changes to that form lately, you may bring back the previously saved form from a backup copy and see how that goes. 03. Make sure that everyone is using the same version and build of R:BASE, including the development environment. 04. Designing and saving a form or report using the latest and greatest builds of R:BASE will generate -ERROR- when running the same form or report under the "old" version/build of R:BASE. Hope that helps! Very Best R:egards, Razzak.
