Yeah have traced not only the button code, but also the entire routine from opening the ap to end...trace never even hesitates on it. That I why I am puzzled.
tom -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Dan Goldberg Sent: Monday, November 09, 2009 1:50 PM To: RBASE-L Mailing List Subject: [RBASE-L] - RE: Unknown Entry/Exit Procedure Error You could trace it to see which command is giving you the error. Just put these commands before the trouble in your eep. Make sure the disable trace is unchecked in the form properties. Set trace on Set debug on Then you can step through it to find the cause of the error. Dan Goldberg -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Thomas Eldred Sent: Monday, November 09, 2009 10:33 AM To: RBASE-L Mailing List Subject: [RBASE-L] - Unknown Entry/Exit Procedure Error Good Afternoon all, I am getting an "Unrecognized command in Entry/Exit Procedure" Error" when clicking a Bit Button and then again when exiting from the procedure inside the button. Everything works in the routine -- that is it does its job, but I cannot find the source of this notice. The form holding the button has no eeps on start, before, after, etc... and neither does the form being called when the button is pushed. I feel I have isolated that it is something to do with the button, being that the notice is not presented until it is clicked. The code for the button is below... Anyone who could provide a clue? Thank you Tom Eldred The code for the button is: --get rush number SET VARIABLE voldpin INTEGER = 0 SET VARIABLE vnewpin INTEGER = 0 SET VARIABLE vrushnum INTEGER = NULL -- 0 means 'no' SELECT rushnum INTO vrushnum FROM people WHERE idnum = .vidnum LABEL rushnumber IF vrushnum IS NULL THEN GOTO newmem ENDIF GOTO contribution LABEL newmem SET VAR vrushnum INTEGER = NULL SET VAR vhighrush INTEGER = NULL SELECT MAX(rushnum) INTO vhighrush FROM people SET VARIABLE vrushnum = (.vhighrush + 1) UPDATE people SET rushnum = .vrushnum WHERE idnum = .vidnum EDIT USING newrushmem GOTO contribution LABEL contribution *{SELECT pinnumber INTO voldpin FROM rushtrans + WHERE contransid IN (SELECT MAX(contransid) FROM rushtrans + WHERE rushnum = .vrushnum) SELECT donortotal INTO voldtotal FROM rushcontview + WHERE datelast = (SELECT MAX (contirbdate) FROM rushtrans + WHERE rushnum = .vrushnum)} SET ERROR MESSAGE 2418 OFF INSERT INTO rushtrans (rushnum, pinnumber, processdate) VALUES (.vrushnum, + .voldpin, .#DATE) EDIT USING rushcont WHERE rushnum = .vrushnum AND processdate = .#DATE *{SELECT pinnumber INTO vnewpin FROM rushtrans + WHERE contransid IN (SELECT MAX(contransid) FROM rushtrans + WHERE rushnum = .vrushnum) UPDATE rushtrans SET pinnumber = .vnewpin + WHERE rushnum =.vrushnum AND processdate = .#DATE} SET ERROR MESSAGE 2418 ON RETURN
