Thank you , it works
From: [email protected] [mailto:[email protected]] On Behalf Of TOM HART Sent: Sunday, 19 September, 2010 11:43 To: RBASE-L Mailing List Subject: [RBASE-L] - Re: Clip Board Use this in on close eep: saverow closewindow return Tom _____ From: CD Conrad <[email protected]> To: RBASE-L Mailing List <[email protected]> Sent: Sat, September 18, 2010 11:12:38 PM Subject: [RBASE-L] - Re: Clip Board Tom, I have set up the form as you suggest and set the variable as vcard. I scan the card and the data shows in the form. I recalculate the variable on closing but when I show var it does not show. chuck From: [email protected] [mailto:[email protected]] On Behalf Of TOM HART Sent: Sunday, 19 September, 2010 10:57 To: RBASE-L Mailing List Subject: [RBASE-L] - Re: Clip Board You could make a variable form and it should scan the number into it. I use the same principle for barcodes. I had an old keyboard with a reader on it and it would fillin the variable field. I don't think you need to copy it to clipboard. Tom Hart _____ From: CD Conrad <[email protected]> To: RBASE-L Mailing List <[email protected]> Sent: Sat, September 18, 2010 10:39:20 PM Subject: [RBASE-L] - Clip Board I am using R:Base 7.5 and we are writing a cash register application and we have just installed a IDtech Stripe Reader. How can I get the information which is written to the clipboard into a variable. I have tried setting the variable before but it does not write to the variable. Appreciate your assistance. Chuck Conrad Jakarta, Indonesia [email protected]
