Razzak: To convert to eXtreme I did an:
1. UNLOAD ALL using Turbo V-8 and then 2. Copied the ".all" and ".lob" files to a new directory 3. Used eXtreme 9.1 to RUN maindata.all I didn't use the FEEDBACK options. I will try that to see if anything shows up. Thanks -- Mike From: "A. Razzak Memon" <[email protected]> To: [email protected] (RBASE-L Mailing List) Date: 04/27/2011 09:42 AM Subject: [RBASE-L] - Re: eXtreme 9.1 performance vs. Turbo V-8 Sent by: [email protected] At 09:21 AM 4/27/2011, [email protected] wrote: >What should I be looking for to figure out why eXtreme is taking >so much longer? Mike, The first and most important question, what steps did you take to convert Turbo V-8 database to R:BASE eXtreme 9.1 (64). A few suggestions: Once converted successfully, make sure to re-build the entire database using the simple technique as follows: CONNECT dbname OUTPUT filename.all UNLOAD ALL OUTPUT SCREEN DISCONNECT RENAME dbname.rx? dbname_bkp.rx? SET FEEDBACK ON RUN filename.all SET FEEDBACK OFF Last but not least, make sure to always use the currently available version and build of R:BASE eXtreme 9.1. http://www.rupdates.com Hope that helps! Very Best R:egards, Razzak. Confidentiality Notice This message is intended exclusively for the individual or entity to which it is addressed and may contain privileged, proprietary, or otherwise private information. If you are not the named addressee, you are not authorized to read, print, retain, copy or disseminate this message or any part of it. If you have received this message in error, please notify the sender immediately by e-mail and delete all copies of the message.
