Stephen, Thank you in advance for your assistance. I've sent a private email to you!
Regards Lena Dammstrom From: [email protected] [mailto:[email protected]] On Behalf Of Stephen Markson Sent: Thursday, May 05, 2011 4:54 PM To: RBASE-L Mailing List Subject: [RBASE-L] - RE: Using SCALEBY PROPERTY in Form ...and then there's the problem of differing screen sizes among users. Use CVAL('SCREENSIZE') to get the user's screen dimensions and do a calculation to get the right SCALEBY factor. Send me a private email and I'll send you the code I use. Regards, Stephen Markson 416 512 6950 ________________________________ From: [email protected] [mailto:[email protected]] On Behalf Of Lena Dammstrom Sent: May 4, 2011 4:00 PM To: RBASE-L Mailing List Subject: [RBASE-L] - Using SCALEBY PROPERTY in Form Good day. Using Rbase Win7.6 I am looking into using PROPERTY RBASE_FORM SCALEBY I looked at the above subject sample application, and the form is 400Wide x 200High, so the SCALEBY is 400 If I change the forms height to anything over 270 high in this example, and I run the form; the bottom of the form runs/disappears off the screen. Is it a general "rule" that if you use the SCALEBY property, you should keep the forms Height to around half the size as the form's width? Or I am missing a property setting that stops the height of the form from scaling off the screen (getting to long/high!) My forms are generally 1000W x 750H, and scaling to 1000, quite a bit of the height of my forms are not seen on the screen when running! Regards, Lena X1037 ________________________________ No virus found in this message. Checked by AVG - www.avg.com<http://www.avg.com> Version: 10.0.1209 / Virus Database: 1500/3614 - Release Date: 05/04/11
