. further to prior post . R>SHOW TIME
TIME format HH:MM:SS TIME sequence HHMMSS Brad From: [email protected] [mailto:[email protected]] On Behalf Of Paul Buckley Sent: Tuesday, October 16, 2012 9:07 AM To: RBASE-L Mailing List Subject: [RBASE-L] - RE: Datetime tutorial Karen, Although I use 9.5, I just tested this in 7.6 and it works fine. Be sure and check you TIME FORMAT settings as Dennis suggested. Mine are set as he indicates, YYYY Paul From: [email protected] [mailto:[email protected]] On Behalf Of Dennis McGrath Sent: Tuesday, October 16, 2012 11:51 AM To: RBASE-L Mailing List Subject: [RBASE-L] - RE: Datetime tutorial Make sure your TIME FORMAT uses YYYY SET VAR vDatetime = .#NOW Should result in a DATETIME I remember I had a lot of trouble with 7.6 until I changed the DATE FORMAT Dennis McGrath Software Developer QMI Security Solutions 1661 Glenlake Ave Itasca IL 60143 630-980-8461 [email protected] From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Tuesday, October 16, 2012 10:09 AM To: RBASE-L Mailing List Subject: [RBASE-L] - Datetime tutorial Here's one for the slow list... So far in my RBase career, I have been blessedly spared from doing time arithmetic. That's about to change. Although this client has purchased some version of 9.x, for the immediate need this will be done in 7.6. I'm still trying to get an answer on whether I need to track time only, or whether I will need a DateTime. I've been playing around with DateTime and am totally confused. I've read all the help screens I could find but mine aren't working that way! If I do: SET VAR vDatetime = .#NOW the datatype is Text and cannot be used for arithmetic If I do: SET VAR vDatetime DATETIME = .#NOW I get an error message about my variable not having the same data type If I do: SET VAR vDatetime DATETIME = (DATETIME(.#date, .#time)) then I do get a datetime variable, and it appears I can use these for arithmetic. If I subtract 2 datetime variables I get an integer which I suspect is in seconds, right? So basically the .#now is not good for calcs? Now part two. I set up a temp table with a column with DATETIME data type, and am incapable of getting a value loaded. Using my now valid DateTime variables, I try to do an insert and I get the same error message above about invalid data types: insert into testklt (onedatetime) values .vDateTime Hard to believe I've gotten away with not a single DateTime in my clients, isn't it?? Well, now I might need to use it. Karen
