This was all my fault. I failed to do the unload and reload after the conversion. Thanks for taking the time to check this out. I was in to much of hurry and hadn't read the full conversion guide. Ron
On Fri, Jan 3, 2014 at 6:25 PM, Javier Valencia < [email protected]> wrote: > What procedure are you using? > > Before I convert I normally run: > > OUTPUT All.bu > > UNLOAD ALL > > OUTPUT SCREEN > > And then recreate the database making sure that there are no error or > conflicts. > > If I recall correctly, when rebuilding the database, the file created > above creates the tables first, loads the data and then recreates the > rules. If you are using this process, it is possible that your data has > conflicts and hence the rule(s) cannot be created. > > For example if you are creating a unique index but the column has > duplicates, the rule will not be created. > > The procedure above should allow you to clean your database and once you > can rebuilt it without any errors, then your conversion will likely go > through without any problems. > > > > Javier, > > > > Javier Valencia, PE > > O: 913-829-0888 > > H: 913-397-9605 > > C: 913-915-3137 > > > > *From:* [email protected] [mailto:[email protected]] *On Behalf Of *Ronald > C Peterson > *Sent:* Friday, January 03, 2014 3:55 PM > *To:* RBASE-L Mailing List > *Subject:* [RBASE-L] - Converting Rules > > > > I am converting a 6.5++ database to 9.5 32 bit and the rules are not > converting properly. The tables referenced in the 9.5 rules are not > correct. Can I unload the sys_rules table from the 6.5 version and then > reload them into the 9.5 after deleting the improperly converted ones? > > Ron Peterson >
