I was trying to determine if your SPACE setting had been corrupted, when makes all two-word SHOW commands fail.
Bill On Fri, Feb 19, 2016 at 3:25 PM, Jim Belisle <[email protected]> wrote: > Shows the same settings (or lack thereof) as what I see when I look at the > config settings choice. > As I said, I have looked at the DB with RCOPE and that did not show any > errors. > It did however show that the settings were messed up. > > I have tried copying over to the directory a CFG file from another > location. That did not work. > I tried fixing the settings while in the explorer mode. It will not allow > me to change anything. > > When I connect in the explorer mode, I get a WRITE error but it does allow > me in the DB. > But then the settings are all wrong. > > > James Belisle > > Making Information Systems People Friendly Since 1990 > [cid:[email protected]] > > From: [email protected] [mailto:[email protected]] On Behalf Of Bill > Downall > Sent: Friday, February 19, 2016 2:15 PM > To: Jim Belisle > Subject: [RBASE-L] - Re: SETTINGS MESSED UP > > Jim, > > At the R> prompt, what happens when you type SHOW [enter]? > What happens when you type SHOW CHAR [enter]? > > Bill > > > On Fri, Feb 19, 2016 at 3:11 PM, Jim Belisle <[email protected]<mailto: > [email protected]>> wrote: > I can open the DB in the explorer mode but I cannot change any of the CFG > settings. > These settings are very strange. > There is a CFG file in the same directory as the DB. > The CFG file has all the proper settings. > I am stumped. > > James Belisle > > Making Information Systems People Friendly Since 1990 > > > > -----Original Message----- > From: [email protected]<mailto:[email protected]> [mailto: > [email protected]<mailto:[email protected]>] On Behalf Of Albert > Sent: Friday, February 19, 2016 1:40 PM > To: Jim Belisle > Subject: [RBASE-L] - Re: SETTINGS MESSED UP > > It sounds as if the CFG file has disappeared. Find a backup and copy it > back into the directory with the R:Base executable. > Albert > > On 2016-02-19 12:04 PM, Jim Belisle wrote: > > We are using RBASE 9.5_64 DB. > > Just a few minutes ago our people started to get an ACCESS violation. > > I haven't seen one of those for years. Once that message came up, others > could not get into the DB. > > After I was informed of the problem (I am odd site) I tried connecting > in the Explorer mode. > > It acted like it was connected but when I looked at the settings, they > were all messed up. > > None of the below areas had a setting at all MANY, QUOTES, PLUS, NULL, > > SINGLE, SEMI, DELIMIT, CURRENCY > > > > I connect with RSCOPE and no errors were found in any area. > > Any Blue's clues as to how to fix this? > > > > James Belisle > > > > Making Information Systems People Friendly Since 1990 > > [cid:[email protected]] > > > > > > >
