Usually crashing in the same place on the program might mean the following
1) if endif or while endwhile loops do not close. You can check this out by
placing the messages on
and wait to see the error at the R>. If snip out the piece of code
around
where the problem is occuring in the program and run it at the >R prompt
you might get a clue as to why its crashing.
2) If it crashs at the form. There can be two reasons for this the form is
corrupt
or variables in the form are the wrong type. You get error messages
when
you open the form and if you list variables you will see
the one in
error.
Debugging is an art and there is no substitue for experience.
All the Best
Victor
> -----Original Message-----
> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On
> Behalf Of A. Razzak Memon
> Sent: Wednesday, 29 August 2001 1:05 PM
> To: [EMAIL PROTECTED]
> Subject: Re: Rbase crashing - Razzak's Reply
>
>
>
> At 11:08 AM 8/28/01 -0500, Charles Sikora wrote:
>
> >I even tried running on a different machine - no difference.
>
> Charles,
>
> In that case, I would suggest to check your command file, EEP(s),
> Form(s), Expression(s), Pre-Defined Variables, and Data Types of
> all Pre-Defined/Global Variables.
>
> Also, the command(s) that run before_or_after that particular
> session(s).
>
> Good Luck!
>
> Very Best Regards,
>
> Razzak.
>
>
> ===================================-============================
> Official R:BASE List Server: mailto:[EMAIL PROTECTED]
> RBTI Events/Training: http://www.rbase2000.com/events
> R:DCC Members: http://www.rbase2000.com/rdcc
> ================================================================
> R:BASE, Oterro & R:Tango are registered trademarks of RBTI.
> ==================================-=============================
>
>
