I used the generic text printer in windows to output two reports to a file then output the file to the printer using type filename. What is happening is I wrote a routine over a year ago that works fine with 6.5 Inline Patch 3. The problem. The first section of the two reports has PH D PF all var are located in the detail section This prints the correct number of line of data output to the file The second section of the two reports has RF all of the var are locate in the detail section What happens with this this report six additional lines are added to the bottom. Where as before what every the number of lines that where printing either 10 or 11 would print. Now I'm getting 16 to 17 line for this section which causes the report to print out two additional plank pages. I'm using new courier fonts because I'm still printing 80 characters wide by 66 lines on a pre printed form! What changed! I'm going to return them to 6.5 inline patch 3 status and put the upgrade on hold! I've not put this question to RBTI just wondering if any one has crossed this before! If there is not easy solution then a complete rewrite of this reporting routine is required! Best regards, *************************************************************** Oma Cox President Office & Computer Services Inc. P.O. Box 1753 365 W. Reed Rd., Ste. 'D' Greenville, MS 38701 662.334.3793 662.335.4200 (Fax) www.ocservicesinc.com [EMAIL PROTECTED] ****************************************************************
