Damon I remember in dos command files I often would have to issue a Newpage command to empty the remainder of the report to the printer.
First, look at the code you use to print the report to make sure you don't have a "new" command after the print command. Second thing, try setting the page footer number to a zero(0) and see if that clears up the problem. Third, unless you really need the page footer to be that big, I would reduce it's size in the report designer and leave the page footer line# at line# 40. Bill Eyring -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of [EMAIL PROTECTED] Sent: Tuesday, December 18, 2001 3:17 PM To: [EMAIL PROTECTED] Subject: Extra Formfeed in Reports I am converting several reports from RBDos 6.5++ to RBWin 6.5++, Build 1.842xRT03, and I'm getting an extra form feed in them after they print. The form feed after report footer is not checked, and the data and footer is clearly not even CLOSE to the end of the page, and less that the page definition length i.e. 65 lines per page, page footer 40, page footer height 8 lines, Times New Roman Font 12 point, all on a HP LaserJet 6P. Report prints, and then there is a blank sheet fed after it's printed. Memory tells me there was a solution for this out there, but I can't remember what it was, and I can't find it. Seems there was something that got embedded in some DOS 4.5++ reports that did this on a conversion, and I can't remember. Report seems to run correctly in RBDos 6.5++, Build 1.842xRT03. Any Ideas out there, other than just re-creating the whole report? TIA Damon Damon D. Kaufman President Stalder Spring Works, Inc ISO-9002 / QS-9000 Certified 2345 S. Yellow Springs St. Springfield, Ohio 45506 Voice 937-322-6120 Fax 937-322-2126 email: [EMAIL PROTECTED] ================================================ TO SEE MESSAGE POSTING GUIDELINES: Send a plain text email to [EMAIL PROTECTED] In the message body, put just two words: INTRO rbase-l ================================================ TO UNSUBSCRIBE: send a plain text email to [EMAIL PROTECTED] In the message body, put just two words: UNSUBSCRIBE rbase-l ================================================ TO SEE MESSAGE POSTING GUIDELINES: Send a plain text email to [EMAIL PROTECTED] In the message body, put just two words: INTRO rbase-l ================================================ TO UNSUBSCRIBE: send a plain text email to [EMAIL PROTECTED] In the message body, put just two words: UNSUBSCRIBE rbase-l
