This is caused from the timeout setting beeing too short. The best solution is what Bernie suggested below. Print it to a file first.
out tempfile.$$$ print rep1 print rep2 out screen set width 240 out printer type tempfile.$$$ out screen ===== Original Message from [EMAIL PROTECTED] at 1/09/02 2:09 pm >Bob - > > Print the two reports to a file and then print the file. > >Bernie >====================================== >At 03:54 PM 1/9/2002 -0500, you wrote: >>I have an unusual occurrence and wondered if anyone has had a similar >>problem. I have a dual DOS report that prints the first report then the >>second report and it all links up on the same page. >>OUT PRINTER >>PRINT REPORT1 >>PRINT REPORT2 >>OUT SCREEN >>There is no report footer in the first repot nor a form feed. Lines are >>set to 0 on first report. This has worked fine for 4 years and now there >>is a form feed after the first report prints. This ONLY happens when it is >>printing to a network queue, works OK when directly to LPT1. Tried this on >>several printers.... Looked at network settings and printer settings, >>nothing new. Network adminisrator (Novell) made no changes that he will >>attest to...... >>Any ideas? >> >>Thanks, >>Bob Castanaro >> >> >>================================================ >>TO SEE MESSAGE POSTING GUIDELINES: >>Send a plain text email to [EMAIL PROTECTED] >>In the message body, put just two words: INTRO rbase-l >>================================================ >>TO UNSUBSCRIBE: send a plain text email to [EMAIL PROTECTED] >>In the message body, put just two words: UNSUBSCRIBE rbase-l >> > >================================================ >TO SEE MESSAGE POSTING GUIDELINES: >Send a plain text email to [EMAIL PROTECTED] >In the message body, put just two words: INTRO rbase-l >================================================ >TO UNSUBSCRIBE: send a plain text email to [EMAIL PROTECTED] >In the message body, put just two words: UNSUBSCRIBE rbase-l ================================================ TO SEE MESSAGE POSTING GUIDELINES: Send a plain text email to [EMAIL PROTECTED] In the message body, put just two words: INTRO rbase-l ================================================ TO UNSUBSCRIBE: send a plain text email to [EMAIL PROTECTED] In the message body, put just two words: UNSUBSCRIBE rbase-l
