[RBG7-L] - RE: Pause message cannot be cleared when printing a report to the screen

[Walker, Buddy]

Alastair   The work around I came up with was     Create a form with sometime type of Anamited avi file. I've tried using anamited gif but when they will not work until have the pri job is finished.       In the form "on after start" eep insert your print statment             PRI USMLE OPTION SCREEN|WINDOW_STATE MAXIMIZED        LABEL Done1         CLOSEWINDOW        RETURN       Hope this helps   Buddy     -----Original Message----- From: Alastair Burr [mailto:[EMAIL PROTECTED] Sent: Thursday, September 23, 2004 4:03 AM To: RBG7-L Mailing List Subject: [RBG7-L] - Pause message cannot be cleared when printing a report to the screen I hadn't noticed this before the most recent update (#77) but it may have happened.   I use these two commands because it takes a few minutes for the reports to be produced:   PAUSE FOR 3 USING .vMessage CAPTION .vCaption +       &vPauseIcon &vPause_Go_Options PRINT &vReport WHERE &vWhere_Clause = .vSelID ORDER BY &vSort_Clause +   OPTION SCREEN |ZOOMPERCENT 100 |WINDOW_STATE MAXIMIZED When the report appears on the screen the pause message cannot be closed. However, the report can be accessed to change pages or to close the report.   With forms there is the ability to use a CLS in an On-After-Start EEP. Is there anything similar that can be done with reports?   Regards, Alastair.   ---------------------------------- A D B Burr, St. Albans, UK. ---------------------------------- [EMAIL PROTECTED] ----------------------------------