In addition to what I wrote in my other message, I tried setting
whileopt off before calling the block and then turning it on. Still
doesn't work.
A. Razzak Memon wrote:
At 04:51 PM 10/17/2004 -0400, Kayza Kleinman wrote:
I have an app file that I've codelocked to apx.
It's been working fine, until I added one module.
When I try to run it from the apx directly, I get
a series of "unrecognized command" errors. When
I run the same apx using a trace command, it works
fine.
Kayza,
Remember, TRACE always runs as WHILEOPT OFF.
(the DEFAULT is ON)
01. Check to make sure that the variables are
pre-defined correctly with correct data types.
(especially in your new block/module of code)
02. Verify all database CHARacter SETtings in
your command to match with the database.
Good luck!
Very Best R:egards,
Razzak.
--
Kayza Kleinman
Director, Nonprofit Helpdesk
Jewish Community Council of Greater Coney Island, Inc.
3001 West 37th Street
Brooklyn, NY 11224
Tel. 718 449-5000
Fax 718 946-8240
[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]>
www.nphd.org <http://www.nonprofithelpdesk.org/>
“Putting Technology to Work For You”
