OK I read it through. (actually I think I did read it before, it obviously didn't sink in.) I understand but to make sure.. In James' example for the plugin (PLUGIN Num2Wrd.RBL vResult|.v1), the reason you need to use an ampersand variable in place of 'vresult|.v1' is because it's part of the PLUGIN command as opposed to a comparison value. Right?
-----Original Message----- From: Dawn Oakes Sent: Wednesday, February 09, 2005 2:16 PM To: RBG7-L Mailing List Subject: [RBG7-L] - Re: Using Num2Wrd.RBL PLUGIN in R:BASE 7.xandV-8 And I thought I looked through all the FTE articles !!! Thank you - I'll read it through. -----Original Message----- From: A. Razzak Memon [mailto:[EMAIL PROTECTED] Sent: Wednesday, February 09, 2005 2:03 PM To: RBG7-L Mailing List Subject: [RBG7-L] - Re: Using Num2Wrd.RBL PLUGIN in R:BASE 7.xandV-8 At 12:38 PM 2/9/2005, Dawn Oakes wrote: >..I'm wondering if someone has a few minutes for a little lesson. >I tend to get confused as to when I need to "enclose" a command string >in a & variable and when I don't. I always figure it out eventually, >but was wondering if someone could provide a technical explanation ... Dawn, From The Edge: http://www.razzak.com/fte (11/18/2001) Topic: Understanding Dotted vs. Ampersand Variables Search Articles | Topic Header | Ampersand | Search ... Hope that helps! Very Best R:egards, Razzak.
