My Atlantis has had occasional ghost shifting issues since I first built it up. Usually when standing up to pedal, only in the middle cogs (highest and lowest cog are fine).
Things I've tried: - The whole drive train has been replaced a few times as I've worn it out. I've learned the hard way and keep a careful eye on chain stretch and tooth wear. So the problem is probably not the drive train. - The silver bar end shifters are tight, probably tighter than needed. I've tried beeswax, replacing the plastic thingies. Pretty sure they are not slipping, the problem is probably not in the shifters. - Tried using a cable liner along the bottom bracket shell. The thing tends to slip up and become useless after a few dozen shifts and I don't think it is making a difference even when properly aligned. The problem could be here. At this point I'm thinking it's the frame – either the bottom bracket shell cable routing or excessive frame flex. I'm thinking of tapping the bottom bracket shell to install a proper cable route. Anyone tried that? Anyone else dealt with this issue on largish Atlantis or other similar Rivs? -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/rbw-owners-bunch. For more options, visit https://groups.google.com/d/optout.
