I fit a Tektro brake hanger and Nitto M12 to my KOM fork. I took the opposite approach, and filed down the "knuckle" on the rack's mounting stud to fit inside the brake hanger. The M12 is stainless, so I'm not worried about the exposed brass and steel.
On Wed, May 13, 2015 at 9:24 AM, Ginz <[email protected]> wrote: > Reviving an old thread that I found useful last night... > > I managed to mount the Nitto Mini rack to a Hunqapillar fork that, because > of brake shudder, requires the Tektro brake hanger that mounts to the fork > crown. The rack and the hanger need to coexist in the fork crown hole. > However, the hanger changes the angle of the rack such that the stays don't > align with the fork's braze-ons (not even close) > > This was my solution: > > Step 1: Dremel out the recess in the Tektro hanger so that the "knuckle" > on the Nitto rack's mounting stud recesses into the Tektro hanger. The > toothy washer is still required behind the brake hanger. > Step 2: Put the rack into a bench vice and trim the mounting stud by maybe > 50mm > Step 3: Find the shortest recessed allen nut you can (from an old > sidepull brake), trimming it with a hacksaw if necessary. This will replace > the nylock nut that comes with the rack. > Step 4: Test fit. Bend the rack's mounting stud a bit allowing the stays > to better align with your fork's braze-ons or p-clamps. It shouldn't take > much bending. > > Done! > > I considering doing something with a Mark's rack but I already had the > Nitto Mini and am happy with the results. > > Ginz > > -- > You received this message because you are subscribed to the Google Groups > "RBW Owners Bunch" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at http://groups.google.com/group/rbw-owners-bunch. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/rbw-owners-bunch. For more options, visit https://groups.google.com/d/optout.
