I'm with Patrick Moore on this one. If you didn't replace the bottom bracket when you replaced the crank, I'd look there. Those old Shimano triples use wide spindles, ~125mm wide. The Sugino XD2 uses a 107-113, depending on the chainstay width. For your bike, I would guess anything in the range would be fine. But if you've got the Sugino on a 120mm+ spindle, I think your big ring might very well be just outside of the pull range of the shifter.
On Monday, May 15, 2017 at 6:03:26 PM UTC-4, John Hawrylak wrote: > > Jeremy & others > > Thanks for the ideas. to addresses Jeremy's & other comments: > > The LBS disassenmbled the left bar end and said it was all there. I'll > remember to check the orientation of the tab. I left others do the work. > I remember the tab when I initially installed the bar ends > > The MT-60 FD is less than 2 mm from the top of the big ring with chain on > the middle. Any closer would invite rubbing. Before the XD2 I had Biopace > with a 50T and swapped to 48T without adjusting the MT60 height. No > problems > > I'll have to check the amount of cable tension in the lowest gear. > > John Hawrylak > Woodstown NJ > > >>>> >>>> -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to rbw-owners-bunch+unsubscr...@googlegroups.com. To post to this group, send email to rbw-owners-bunch@googlegroups.com. Visit this group at https://groups.google.com/group/rbw-owners-bunch. For more options, visit https://groups.google.com/d/optout.
